
Round Electromagnets
Flat-faced round electromagnets or holding solenoids from 0.50" to 4.0" dia. These APW electromagnets or holding solenoids available with either thru hole mounting or a female tapped mounting threads. Round holding solenoid electromagnets are available in 3 vdc to 230 vac voltages holding 2 to 640 lbs.
-
Round, Holding Electromagnet, .50" Dia with 12 VDC
This industrial electromagnet magnet is equipped with 12 volts of direct current with 2 pounds of magnetic suck. It is not a quick release and does not offer encapsulation or include an anti-rotation pin.
Features:
- Electrical- Voltage: 12, Current: DC
- Bolt Desc. or Thread Female 6-32
- Holding Force: 2 pounds
- Outer Diameter: .5 Inches
- Height: .5 inches
- Amps: 0.08
- Lead Wire Ga: 28
- Duty continuous
- Lead Wire Length: 11 inches
The included tapped rear-threaded mounted option offers superior versatility. The mounting screw is not provided and the lead wire type is a TFE. This magnet cannot handle high temperatures (i.e. above 500 degrees fahrenheit) nor is it magnetic stainless (430 FR).
*The holding force for this round electromagnet is tested on a load cell under a standardized test method. Our standardized test includes direct contact with a bare 1215 CRS ground strike plates. The plates are .240” thick and are either greater than or equal to the diameter of the electromagnets.
EM050-12-222-A
-
Round Electromagnet, 0.50" Dia With 12 VDC
This industrial electromagnet magnet is equipped with 12 volts of direct current with 2 pounds of magnetic suck. It is not a quick release and does not offer encapsulation or include an anti-rotation pin.
Features:
- Electrical- Voltage: 12, Current: DC
- Bolt Desc. or Thread Female 2-56
- Holding Force: 2 pounds
- Duty continuous
- Amps: 0.08
- Lead Wire Ga: 28
- Lead Wire Length: 11 inches
- Outer Diameter: .5 Inches
- Height: .5 inches
The included tapped rear-threaded mounted option offers superior versatility. The mounting screw is not provided and the lead wire type is a TFE. This magnet cannot handle high temperatures (i.e. above 500 degrees fahrenheit) nor is it magnetic stainless (430 FR).
*The holding force for this round electromagnet is tested on a load cell under a standardized test method. Our standardized test includes direct contact with a bare 1215 CRS ground strike plates. The plates are .240” thick and are either greater than or equal to the diameter of the electromagnets.
EM050-12-222
-
EM400-24-212
4.0" Dia. 24-volt DC Electromagnet, holding - 640 lbs. Accommodate a lighter load with this strong 24-volt electromagnet of the same size.